Reset Brother MFC-465CN

Reset Brother MFC-465CN

The thread will share how to Reset Brother MFC - 465CN 

To reset purge counter

1) Enter machine maintenance mode (on MFC240C all four photo/copy/fax/scan lights flash in maintenance mode). Care is needed in maintenance mode, otherwise critical settings may be inadvertently corrupted.


FAX models with numerical keypads: Press the Menu/Set, *, 2, 8, 6 and 4 keys within two seconds. (if you fail to complete the correct key sequence within two seconds, press the Stop key to try again).


Other (non-FAX) models: Press the Menu/Set and Black Start keys. Next press the “up arrow” key four times to enter the maintenance mode).


2) Press the 8 then 0 keys in the initial stage of the maintenance mode to call up the machine’s log information list (function code 80).


3) Press the Black Start key several times to scroll through the log information list 
to reach the purge counter. The purge counter is the 25th item in the list.


4) Press the 2, 7, 8, and 3 keys in this order to reset the purge count to zero.


5) Press the Stop/Exit key to return to the initial stage of the maintenance mode.


6) Press the 9 key twice to return to the standby state.


Or step by step - Gia Tin Support


1.pull out the AC plug

2.put back the AC plug while holding down the "menu" button and keep holding it (15 sec)

3.now you are entering the MAINTENANCE mode and "error 46" pops up in the display

4.select 8 by using the arrow buttons ,push OK and select 0 and push OK

5.00:00 00:01 OK (the display is showing this message)

6.now push the MONO button 25 times until you see PURGE: xxxxx

7.Select 2, 7,8,3 and push ok

8.the purge counter indicates now: purge: 00000

9.switch off the printer ,switch it on

ready to print